|
ICOM IC-7200
HF/50MHz
TRANSCEIVER
Simple & Tough
with IF DSP
ICOM IC-7200
IF DSP
The
latest IF DSP technology is employed in the IC-7200.
While the IC-7200 is an entry-class transceiver,
advanced digital features are comparable to higher class
transceivers.
AGC loop management
Distortion and blocking from strong
nearby signals are prevented by placing DSP functions
inside the AGC loop. The AGC time
constants are selectable from fast, slow and off for
each operating mode.
Digital IF filter
Optional filters
will be never required for the IC-7200. The built-in
digital filter allows you to flexibly select the filter
width and shape from soft and sharp* and provides
cuttingedge filter characteristics.
* Filter shape is selectable for SSB and CW modes only.
Digital Twin PBT
Only Icom brings
you Twin Passband tuning!
Tailor your IF passband with the Twin
PBT by electronically shifting the upper and lower edges
of the IF filter. Depending on the use of the concentric
knobs, you can either narrow the IF passband, or shift
the entire passband to eliminate interfering signals.
Manual notch filter
The manual notch
filter delivers more than 70dB of attenuation. Strong
interfering tones will be eliminated without adversely
affecting the AGC loop performance. On the bottom right
of the front panel, a dedicated control knob adjusts the
notch filter frequency.
Digital noise reduction
Digital noise
reduction reduces background noise and improves the
signal-to-noise ratio. The noise reduction level is
adjustable in 16 steps. It improves the readability of
voice and data signals.
Digital noise blanker
The noise blanker reduces pulse-type
noise such as engine ignition and sparking.
The NB
level and width (blanking duration) are adjustable in
100 steps.
High stability transmitter
The
DDS (Direct digital synthesizer) creates a clear, clean
transmit signal and improves the C/N ratio. With a
dual-fan cooling system, the IC-7200 provides stable
high quality output even during high duty cycle
operation.
USB port for PC control
The IC-7200 can
be controlled by a PC through a USB port using the CI-V
data format. In addition, modulator and received audio
can also be transferred over the USB cable. By using
appropriate external software, you can record incoming
call and/or transmit preprogrammed messages from your
PC.
RF speech compressor
The digital RF
speech compressor increases your average talk power in
SSB mode. Even when the compression level is increased,
the DSP controlled RF speech compressor provides low
distortion audio.
CW mode operation
Full break-in,
selectable CW carrier point (USB or LSB) and adjustable
CW pitch are also standard.
Tough construction against water intrusion
Waterproof
protection technologies that are used in Icom’ s marine
radios are applied to the buttons and knobs on the front
panel to provide a measure of protection against water
intrusion.
*IC-7200 is NOT waterproof.
Rugged design for outdoor use
The rugged
design of the IC-7200 means your enjoyment of this rig
is not limited to your shack only.
Other features
• RIT
• VOX
• ±0.5ppm
frequency stability
• LCD
backlight (Hi/Lo/Off)
• CI-V
interface
• 201 memory
channels
• Built-in
20dB attenuator
• Preamplifier
• Dial lock
• Auto TS
function
• 1Hz step
tuning
• Band
stacking register
• Built-in
voice synthesizer
• Quick split
• Front facing
speaker
• Quick set
mode
Rear
bumper”
The
“rear bumper” protects various connectors on the rear
panel and lets you stand the radio on its rear end when
the antenna is disconnected, such as while moving or
packing the radio.
|
