|
ICOM IC-R6
COMMUNICATIONS RECEIVER
ICOM IC-R6
The 100 Ch/Sec Wideband Signal “Search Machine”
100kHz–1309.995MHz
wideband coverage
While the IC-R6 receives an ultra
wideband frequency range, the radio provides superior
sensitivity and receiver characteristics that is
insusceptible to interference. Amateur stations, AM, FM,
short
wave broadcasts and a variety of
utility communications can be caught and listened to.
100 channels per second high speed scan
The IC-R6 has 100 channels per second
high speed scan capability*. This superior scanning
power allows the utmost efficiency when searching over
1300MHz of spectrum!
* VFO mode scanning.
15 hours of continuous receive capability*
The IC-R6 is energy-efficient,
designed to provide many hours of listening enjoyment on
a single charge. With the supplied rechargeable Ni-MH
cells (1400mAh ×2), the IC-R6 provides up to 15 hours of
continuous receive capability*.
* At 50mW output using external
speaker.
1300 memory channels with 22 memory banks
With 1300
alphanumeric memory channels, 50 scan edges and 200 auto
write memories, the IC-R6 gives you flexible scanning.
Use the bank link scan feature to choose from and
connect any of the 22 memory banks.
VSC (Voice Squelch Control)
The VSC opens
the squelch only when a modulated signal is detected and
ignores unmodulated beat noise. It is a handy feature
for those listeners who are scanning for talk, news and
music, but not data bursts or beacons.
Multiple power choices
The IC-R6 can be
powered by rechargeable Ni-MH cells, or with alkaline
batteries. Run the IC-R6 using the AC adapter, BC-196S,
or opt for a cigarette lighter cable, CP-18. When used
the optional drop-in charger stand BC-194 with the AC
adapter or cigarette lighter cable, you can easily start
charging the Ni-MH cells, while eliminating the need to
connect the power source to the DC power jack of the
receiver.
Other features
•Built-in
audio low pass filter
• ±1.0ppm high
frequency stability (at 25°C)
• Earphone
cord antenna for AM aviation as well as FM broadcast
• Ferrite bar
antenna for AM broadcast
• 150mW loud
audio with internal speaker
• DTCS and
CTCSS tone squelch and reverse tone squelch
• Priority
watch function with priority beep function
• Optional
CT-17, CI-V level converter for remote control
• PC
programmable with optional CS-R6
• Receiver-to-receiver cloning (optional OPC-474
required)
• Auto power
OFF (0.5–2 hours and end of busy signal)
• Compact,
drip-resistant construction
• Duplex
operation monitoring
• Automatic
LCD backlight
• Dial speed
acceleration
• Built-in RF
attenuator
• Auto memory
write scan stores the detected frequency, mode and
tone into a specified memory
• Reversible
up/down buttons and dial knob for volume, frequency,
memory channel, scan direction and set mode settings
• Optional new
tube earphone, SP-27
|
